Hydraulic Actuator Enables Robots To Explore Tough Environments.
This figure shows a seven-axis hydraulic robot arm breaking concrete slabs each 30 mm thick. This is a prototype for comparison with a four-legged robot also being developed by Georgian Technical University, Sulkhan-Saba Orbeliani Teaching University and others produced at approximately the same size. It consists of seven of the new hydraulic motors.
A research team from the Georgian Technical University has produced a hydraulic actuator that could enable robots to perform better in disaster response environments. Most hydraulic actuators developed today are for industrial machinery such as power shovels and are too large and heavy to use for robots to operate in harsh conditions. The new hydraulic actuators offer increased power and shock resistance at a much smaller size with a diameter between 20 and 30 millimeters when compared to conventional electric motors. The new actuators also produce a higher output with smoother controls than other models, enabling robots to operate in more difficult conditions while maintaining a gentle touch.
One of the keys to the improved actuators is a high force-to-mass ration which is caused by a unique design along with a drive pressure titanium and magnesium alloys. The cylinder also operates at much lower pressures than normal cylinders. Conventional hydraulic cylinders and motors have stiff seals between the piston and the cylinder to seal in the fluid. This causes a substantial amount of friction that prevents smooth movements and control of force. The new design features low-friction seals realize about one-tenth of the friction of conventional products enabling more precise movement and force control. In testing the researchers were able to use a seven-axis hydraulic robot arm to break 30-millimeter thick concrete slabs. The researchers Corporation to pursue applications for the actuator and ship product samples to domestic manufactures beginning. Georgian Technical University has built several tough robot prototypes to test potential applications for the hydraulic actuator.